sleepy
This is an old revision of the document!
−Table of Contents
Sleepy
- Connect ground to SD0 (see stackoverflow)
- Raspi ↔ GPIO connector, make sure ribbon cable connected right (silver up at Raspi, blue up at adapter)
- permissions
sudo usermod -G i2c pi
Accelerometer
| RasPI | Buchse | Sensor |
|---|---|---|
| 3V (rot) | Pol 4 (oberer Kontakt) | (braun) VCC |
| GND (schwarz) | Pol 3 (hinten oben) | (Litze) GND |
| SCL (orange) | Pol 2 (hinten links) | (grün) SCL |
| SDA (brown) | Pol 1 (hinten rechts) | (weiß) SDA |
Temperature
https://learn.adafruit.com/adafruits-raspberry-pi-lesson-11-ds18b20-temperature-sensing/hardware
| Orange | 3V |
| Yellow | GPIO #4 |
| Green | GND |
Speaker
GPIO 18
right input and output
mono files
sleepy.1429878373.txt.gz · Last modified: 2015/04/24 12:26 by andi